Changes between Version 2 and Version 3 of Ja:HowTo

Timestamp:

2009-10-18T16:42:24+02:00 (15 years ago)

Author:

bastiK

Comment:

link images to english version

Ja:HowTo

@@ -31 +31 @@
 
  * Draw a single line, approximately as long as the diameter of the roundabout.
-[[Image(roundabout1.png)]]
+[[Image(wiki:HowTo:roundabout1.png)]]
 
  * Select the line and use ''Tools -> Create Circle''.
-[[Image(roundabout2.png)]]
+[[Image(wiki:HowTo:roundabout2.png)]]
 
  * If you think, it is not round enough, add more nodes and use ''Tools -> Align Nodes in Circle''.
 
  * Move the circle on top of the crossing.
-[[Image(roundabout3.png)]]
+[[Image(wiki:HowTo:roundabout3.png)]]
 
  * You can rotate the circle holding CTRL+SHIFT in ''Select'' mode.
@@ -48 +48 @@
 
  * Click into some empty area to clear the selection. Select the central node again (there are two of them on top of each other now), and move it a bit. The two ways should be separated now.
-[[Image(roundabout4.png)]]
+[[Image(wiki:HowTo:roundabout4.png)]]
 
  * Select one of the two nodes an press P (''Tools -> Split Way''). Select the same node again, unglue it (shortcut G), reselect it and move it a little.
-[[Image(roundabout5.png)]]
+[[Image(wiki:HowTo:roundabout5.png)]]
 
  * Repeat with the other way; you should have four loose ends now.
 
  * Move these ends approximately to where they should dock to the circle.
-[[Image(roundabout6.png)]]
+[[Image(wiki:HowTo:roundabout6.png)]]
 
  * Click on one of the ends and press A.
 
  * Click on the circle to add the way to the roundabout. (Either snap to one of the existing nodes or click on the segment to add another node.)
-[[Image(roundabout7.png)]]
+[[Image(wiki:HowTo:roundabout7.png)]]
 
  * Select the same node again and press the ''Delete'' key to remove it.
@@ -69 +69 @@
  * Done!
 
-[[Image(roundabout8.png)]]
+[[Image(wiki:HowTo:roundabout8.png)]]
 
 Notes: